The driver operates in PIO mode only. Depending on the block size (512
bytes versus 128 KiB), it has a troughput of 2 MiB/sec - 10 MiB/sec for
reading and 173 KiB/sec - 8 MiB/sec for writing.
Fixes#1475
This patch enhances the generic SD-card protocol implementation in
sd-card.h with the ability to handle the version 1.0 of the CSD register
(containing the capacity information of older SD cards).
The emergency dataspace is used to accommodate the corner case where
a signal context capability is created while issuing the first
resource request. Normally, the attempt to upgrade the signal-session
quota under such a constrained situation would fail. By freeing the
emergency dataspace in this situation, we regain enough quota to
upgrade the signal session.
This is a follow up commit for "base: Raise RAM quota of signal session
to 16K" and fixes the resource_request test on 64-bit platforms.
A Nic::Session client can install a signal handler that is used to
propagate changes of the link-state by calling 'link_state_sigh()'.
The actual link state is queried via 'link_state()'.
The nic-driver interface now provides a Driver_notification callback,
which is used to forward link-state changes from the driver to the
Nic::Session_component.
The following drivers now provide real link state: dde_ipxe, nic_bridge,
and usb_drv. Currently, OpenVPN, Linux nic_drv, and lan9118 do not
support link state and always report link up.
Fixes#1327
If a client acknowledges the same packet more than once, the packet also
gets freed more than once. At the second attempt the underlaying
Bit_array will throw an 'Invalid_clear' exception, which results in an
uncaught exception that leads to an abort() call in the freeing
component.
Fixes#1462.
The driver for the Freescale eSDHCv2 doesn't support the highest
available bus frequency by now and also the bus width may be set to a
higher value but that needs further checks on the capabilities of the
inserted card.
The commits provide a benchmark as it exists for the OMAP4 SDHC driver.
Fix#1458
The GUID partition table (GPT) is primarily used by systems using
(U)EFI and is a replacement for the legacy MBR. For now, the current
implementation is able to address up to 128 GUID partition entries
(GPE).
To enable the GPT support in 'part_blk' it has to be configured
accrodingly:
! <start name="part_blk">
! [...]
! <config use_gpt="yes">
! [...]
! </start>
If 'part_blk' is not able to find a valid GPT header it falls back
to using the MBR.
Current limitations:
Since no endian conversion takes place it only works on LE platforms
and of all characters in the UTF-16 encoded name field of an entry
only the ones included in the ASCII encoding are printed. It also
ignores all GPE attributes.
Issue #1429.
The hover reports provides information about the session currently
pointed-to, i.e., hovered session. It can be enabled by the 'hover'
attribute of nitpicker's 'report' configuration element
<report hover="yes" />
Fixes#1442
Drivers like SD-Card, platform, AHCI, and framebuffer are specified as Exynos5
compliant. But they are at least not compliant with Odroid-XU although this is
Exynos5. Thus, prevent tests that rely on such drivers when building for
hw_odoid_xu. Furthermore, make previous Arndale regulator/consts.h,
uart_defs.h, and some Board_base enums available to all Exynos5 builds to
enable at least building the drivers.
Fixes#1419
For the USB-Armory, we use a newer version of Linux (3.18) as for the
i.MX53-QSB. The main difference is, that the newer Linux uses a DTB instead of
ATAGs.
Fixes#1422
The USB Armory is almost the same as the i.MX53-QSB but it uses only
one of the two RAM banks available in i.MX53. Furthermore we use the USB
Armory only with Trustzone enabled.
Ref #1422
* enables world-switch using ARM virtualization extensions
* split TrustZone and virtualization extensions hardly from platforms,
where it is not used
* extend 'Vm_session' interface to enable configuration of guest-physical memory
* introduce VM destruction syscall
* add virtual machine monitor for hw_arndale that emulates a simplified version
of ARM's Versatile Express Cortex A15 board for a Linux guest OS
Fixes#1405
The handling of MMIO regions now supports more pathological cases with
weird cross references. Also, MMIO regions are releases after the
parsing is done.
Fixes#998
When returning early on directory operations, file systems that might
be able to handle the request but come after the current one are not
tried.
Fixes#1400.
Instead of returning an uint64_t value, return a structured time stamp.
This change is only visible to components using Rtc_session directly.
Fixes#1381.
By blocking on a timeout, we yield the CPU in order to give a
concurrently running sporadic process a chance to obtain ROM modules.
Otherwise, such requests would be deferred until the ROM prefetcher
completes its operation or in the unlikely event that the prefetcher
gets preempted.
Fixes#1378
Instead of fixing the missing dynamic facilities of the AHCI driver
backends for x86 and Exynos5, just avoid to create/destroy the backend
for every new connection, but always use one and the same object.
The AHCI drivers need to be re-written anyway, see issue #1352 for instance,
we can make it more robust for the dynamic case then.
Fixes#786Fixes#1133
When building Genode for VEA9X4 as micro-hypervisor protected by the ARM
TrustZone hardware we ran into limitations regarding our basic daily
testing routines. The most significant is that, when speaking about RAM
partitioning, the only available options are to configure the whole SRAM
to be secure and the whole DDR-RAM to be non-secure or vice versa. The
SRAM however provides only 32 MB which isn't enough for both a
representative non-secure guest OS or a secure Genode that is still
capable of passing our basic tests. This initiated our decision to
remove the VEA9X4 TrustZone-support.
Fixes#1351
Declaring the SP804 0/1 module and its interrupt to be non-secure prevents the
secure Genode from receiving the interrupt and hence the timer driver in the
secure Genode doesn't work.
Fixes#1340
