genode/base-hw/doc/panda_a2.txt
2012-08-22 09:51:31 +02:00

97 lines
3.0 KiB
Plaintext

======================================================
Getting started with 'genode/base-hw' on PandaBoard A2
======================================================
Martin Stein
Abstract
########
This is a short tutorial that depicts a handy way to get a Genode ELF image,
build with 'base-hw', started on the PandaBoard A2. It is dedicated to common
Linux systems, but all examples originate from a Ubuntu 10.10.
Tutorial
########
Connect the PandaBoard to your local Ethernet through its RJ45 connector.
Additionally connect the PandaBoard to your machine through its COM port.
Ensure that you have installed the genode tool chain that is available at:
:[http://genode.org/download/tool-chain]:
Get the genode tool chain]
Ensure that '<GENODE_GCC_DIR>/bin/' is in your 'PATH' variable.
Get the linaro U-Boot repository and compile U-Boot for PandaBoard:
! git clone git://git.linaro.org/boot/u-boot-linaro-stable.git
! cd <UBOOT_DIR>
! make CROSS_COMPILE=genode-arm- omap4_panda_config
! make CROSS_COMPILE=genode-arm-
During the compilation i had some errors. The first was in assembly code,
it seemed to originate from a slip with the typo and was easy to fix.
The second kind of errors occured because the GCC version had no support for
direct array initialization, thus i avoided them by simply initialize
the array elements separately.
Now install the following packages to communicate with the PandaBoard:
! sudo apt-get install tftp-hpa minicom
Open '/etc/default/tftpd-hpa' with a text editor and ensure that it has
the following content:
! # /etc/default/tftpd-hpa
! TFTP_USERNAME="tftp"
! TFTP_DIRECTORY="/var/lib/tftpboot"
! TFTP_ADDRESS="0.0.0.0:69"
! TFTP_OPTIONS="-l"
Tell U-Boot wich image to load on boot command:
! cd /var/lib/tftpboot/
! ln -s <GENODE_BOOT_ELF> image.elf
Start TFTP to enable the upload of the image:
! sudo service tftp-hpa restart
Start Minicom in configuration mode:
! minicom -s
Go to 'Serial port setting' and ensure that the device is set the
TTY of the COM port you've conntected PandaBoard with, in my case it was
'/dev/ttyS0'. Configure the other settings for a baud rate of '115200',
8 bit char length, no parity and 1 stop bit. Quit Minicom and start
it once more:
! minicom
Mount your SD-card and copy the U-Boot files to its boot partition:
! cd <UBOOT_DIR>; cp MLO /media/boot/; cp u-boot.bin /media/boot/
Unmount the SD card and insert it into the appropriate PandaBoard slot.
Plug in the power connector or push the 'S1' button if the PandaBoard is
already powered.
Minicom should now show the following message:
! Hit any key to stop autoboot:
We have to stop autoboot and type in this line to load and boot the genode
image via ethernet:
! usb start; dhcp; bootelf 0x82000000
Now the ELF image should start correctly and offer some debug output in
minicom. You can now boot further images by redirecting the link
'/var/lib/tftpboot/image.elf' accordingly, restarting your pandaboard
and instructing 'uboot' again as described above.